To guarantee the best possible image quality, and to detect any malfunctioning, regular quality control is recommended.
The different parameters in MRI control include: the signal, geometric parameters, NMR, artifacts and spectroscopy.
The main signal parameter is the signal-to-noise ratio measurement. The measurement is carried out:
- either by selecting regions of interest in void zones (air)
- or in a region of interest corresponding to the subtraction of 2 images of a homogeneous phantom.
The uniformity of the emitting coils must also be evaluated, as heterogeneity of radiofrequency emission could lead to differences in flip angles in the volume, thus modifying contrast. This measurement, given as a percentage, is carried out on a homogeneous phantom, if necessary by sliding the image or increasing the number of acquisitions when the signal-to-noise ratio is low.
The aim of these tests is to check the quality of spatial encoding (slice selection, phase and frequency encoding). Useful criteria in this test include:
- Position, thickness and profile of slice
- Spatial linearity and geometric deformation, in the phase and frequency encoding direction
- Spatial resolution
- Absolute precision and Repeatability of T1 and T2 measurements
- Contrast and contrast-to-noise ratio (figure 8.32) with T1 and T2 weighting
- Chemical shift and fat signal suppression
MR spectroscopy parameters
- Evaluation of the parameters of B0 homogeneity for a centered volume
- Accuracy of signal amplitude and the signal-to-noise ratio of the principle peaks
Olea Medical® case report on early & late MR diffusion follow-up of a stroke using CT perfusion.
Ziehm Vision RFD Hybrid Edition: Mobility and flexibility – the difference in an emergency
Olea Medical® literature meta-analysis on CTP thresholds in acute stroke
Agfa HealthCare Special Report Dose Management: because life is precious.
Pourquoi avoir une gestion en temps en réel de la dose d'irradiation des patients ?
BRACCO IMAGING FRANCE